Yangzhou Zhongli International Trading Co.,Ltd
Categories
Home > Exhibition > Content

Punching principle of why cam controller

1 motor drive by clutch drives the flywheel turn around (transmission drives the slider-crank mechanism of reciprocating) is a trip. 2 trip control has Shang dead (in situ started and stop) Xia dead, and anti-again trip, and photoelectric protection, and cushion control, and hands button operation, and Automation control, and belt machine, requirements, that many of timing control selected pass and requirements; will a trip as a 360 degrees of movement cycle, each cam representative a timing conditions and selected pass angle, more group composition has cam controller; large equipment both configuration mechanical cam and has electronic cam tie using. 3 practical controller adjust the cam angle, start angle and disconnect the angle, the corresponding switch conduction to normal according to time requirements, put into debugging use. Stamping equipment 4 cam allocation table instance.

Contact Us
Address: No.228# Center Avenue Chennan New District, Gaoyou City, Yangzhou, Jiangsu Province, China
Tel: +8618921925086
 Fax:+86-514-84606186
 E-mail:sales@yzzlco.com
Copyright © Yangzhou Zhongli International Trading Co ltd All rights reserved.
Share: