Yangzhou Zhongli International Trading Co.,Ltd
Categories
Home > Exhibition > Content

About punch die pad and

Punch die-pad is usually used to under the cushion in the die, which is used to adjust due to the limitations of the shut height of press, makes small molds and machined in large punch. In addition, because punching table has a big hole in the Middle, some small mold without pads, molds are bottom contact area is small, and effect on strength, pad die-pad will be able to increase the strength of the mold. Two rectangular die-pad is iron, with flat grinding makes two horns below parallel.

Previous: Punching principle of why cam controller

Next: No Information

Contact Us
Address: No.228# Center Avenue Chennan New District, Gaoyou City, Yangzhou, Jiangsu Province, China
Tel: +8618921925086
 Fax:+86-514-84606186
 E-mail:sales@yzzlco.com
Copyright © Yangzhou Zhongli International Trading Co ltd All rights reserved.
Share: